Material fit
PET bottles, film, pipes, sheet, woven bags, jumbo bags and ABS/PS housings.
A granulating crusher that brings shredded or loose plastic down to flake size for washing, drying and granulation, with screens to set the output.
Washing efficiency and granulator performance both depend on particle size. The PS series is specified by the size the next stage needs, not by nominal tonnage alone.
PET bottles, film, pipes, sheet, woven bags, jumbo bags and ABS/PS housings.
SKD-11 blade material, water-cooled bearing housing and anti-blocking chamber design.
Flake size set by screen; screens are interchangeable for different downstream requirements.
Values as published. Screen options are 3, 5, 8, 10 and 15 mm depending on the target flake size.
| Model | Rotor diameter | Power | Blades | Capacity | Feed opening |
|---|---|---|---|---|---|
| PS-300 | Ø300 | 15 kW | 9 | 150-300 kg/h | 400×300 mm |
| PS-400 | Ø400 | 22 kW | 12 | 300-500 kg/h | 500×400 mm |
| PS-500 | Ø500 | 37 kW | 15 | 500-800 kg/h | 600×500 mm |
| PS-600 | Ø600 | 55 kW | 18 | 800-1,200 kg/h | 700×600 mm |
| PS-800 | Ø800 | 75 kW | 24 | 1,200-2,000 kg/h | 900×800 mm |
Published figures. Output size depends on screen selection; capacity depends on material and feed size.
Blade geometry is matched to the material rather than fixed at one profile.
Suited to film and woven bags — fine output at high throughput.
Suited to sheet, pipe and board — strong crushing force.
Suited to PET bottles and hard plastic — efficient with easier blade changes.
Clean the chamber each shift, inspect blades weekly, grease bearings monthly.
Crushers are normally followed by friction washing and dewatering.
Screen choices run from 3 mm to 15 mm, giving an output typically in the 5-20 mm range depending on material.
Yes, with the appropriate blade profile and feed opening. For very bulky feed, a shredder is placed ahead of the crusher.
No. The crusher is not designed for metal or stone; metal removal is recommended upstream.
By required flake size, hourly capacity, feed size and the material type — the model is confirmed with the rest of the line rather than in isolation.